How To Build Large L Shaped Desk – No matter how much space you have, you always need more. Take advantage of all the nooks and crannies in your house to use all your space in the most efficient manner possible. You can also convert a corner in your hallway to an office space by building an L-shaped desk. By building it yourself, make sure that the table fits perfectly into the nook, making available practical use of space.
Instructions to build large l shaped desk, measure the width and depth of the nook in inches. On plywood, draw the outline of the pieces you need to cut. Two pieces must be 30-of-18 inches; One piece is the width of the nook by 18 inches. Another is the depth of 18 inches with nook subtracted from this measurement, with 18 inches. Cut out the pieces disposed with a band saw. Place the cutting blade to 18 inches less than the depth along its side. Did the 18-inch side of one of the 18-by-30-inch bits up to the end edge of one of the 18-inch ends so that they match? Screw the pieces together using a power. Place a screw in each 4 inches. Fill in indented screw areas with wood filler. When it dries, sand it down to make it even with the wood filler.
12 Photos Gallery of: How To Build Large L Shaped Desk
Next steps to build large l shaped desk, lay piece of plywood cut to the width of the nook on their side. Place the other piece that is 18-of-30 inches up to a base edge of the other piece. Screw it into place by the top of the piece cut to width. Fill the screw holes with wood filler and sand it down when the putty dries. Paint pieces in your choice of color. When dry, put the piece cut to the width of the corner of section 18 by-30-inches to the side wall of the nook to the left. Go over the play once it is in place and screw the two L-brackets. Each should be 12 inches from either the wall. Screw in the bracket in the top of the desktop and screw the side of the bracket to the wall. Place the other along the right side of the nook 18-by-30-inch piece outward. Make sure it is flush with the second piece. On each side of the splice, attach an L-bracket.